WHITEWATER R.C.
Would you like to react to this message? Create an account in a few clicks or log in to continue.
WHITEWATER R.C.

Whitewater WI radio control club


You are not connected. Please login or register

Having fun building

4 posters

Go down  Message [Page 1 of 1]

1Having fun building Empty Having fun building 1/28/2016, 3:59 pm

rwcd

rwcd

Having fun building Dsc_0010

2Having fun building Empty Re: Having fun building 1/28/2016, 9:41 pm

rprager

rprager

Cool Roger. What ya building? Cool Cool

3Having fun building Empty Re: Having fun building 1/28/2016, 10:12 pm

rwcd

rwcd

An OS 25 powered Robin hood 25 bounce bounce bounce bounce bounce

4Having fun building Empty Re: Having fun building 1/29/2016, 8:20 am

sblock

sblock

Your actually building it with a glow motor. (Ah VINTAGE HAY COOL)  Cool Cool Cool

5Having fun building Empty Re: Having fun building 1/29/2016, 9:12 am

rwcd

rwcd

It's fun cleaning all the goop off the plane. Using after run oil. Run it dry. Very Happy Very Happy Very Happy Very Happy

6Having fun building Empty Great Flyer 1/30/2016, 11:19 am

teeceeveecee

teeceeveecee

Hey Roger-

Great flyer, covered mine with Solartex and powered by Saito .30.

Never used a drop of after run in my life and never run dry, NEVER had a bearing failure or a scored cylinder. BUT, I always use fuel with a blend of castor/synthetic. Prefer SIG 4-Stroke, did use Powermaster but they sell six gallon cases too much to buy at one time . SIG is better anyway. Remember I am OLD OLD school. Cleaning goop therapy !

Looking forward to progress pics.

Tom

7Having fun building Empty Re: Having fun building 1/30/2016, 3:32 pm

rwcd

rwcd

I lost a bearing on an Enya 46 4c. They said it was there fault and replaced it with a bigger bearing.

8Having fun building Empty Re: Having fun building 2/9/2016, 6:22 pm

rwcd

rwcd

Having fun building Dsc_0011

Getting closer

9Having fun building Empty Beautiful Roger 2/10/2016, 6:00 am

teeceeveecee

teeceeveecee

Just beautiful Roger, the Robinhoods all captured the Curtiss Robin look.

Really looking forward to seeing the finished project. There is no better (for a modeler) satisfaction than seeing your work drift by low and slow.

Great work.

Tom

10Having fun building Empty Re: Having fun building 2/10/2016, 8:30 am

rwcd

rwcd

It is nowhere near as good a job as the fellow on one of the forums. And his was scratch built. That fellow was a master builder. Very Happy

Sponsored content



Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum